Server Name Still Present After Erase Utility Is Executed; Troubleshooting A Remote Host - HP ProLiant Gen9 Troubleshooting Manual

•
On the Diagnostic page of the iLO browser interface, click Reset.

Server name still present after ERASE utility is executed

The Server Name field is communicated to iLO through the Insight Manager Agents.
To remove the Server Name field after a redeployment of a server, do one of the following:
•
Load the Insight Manager Agents to update the Server Name field with the new server name.
•
Use the Reset to Factory Defaults feature of the iLO RBSU utility to clear the Server Name field.
This procedure clears all iLO configuration information, not just the Server Name information.
•
Change the server name on the Administration>Access Settings>Access Options page on the iLO
browser interface.

Troubleshooting a remote host

Troubleshooting a remote host server might require restarting the remote system. You can restart the remote
host server by using the options listed in the Virtual Devices tab.
HP iLO errors 260