Functional Description - Makita MGA400 Instruction Manual

24. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
25. Always be sure that the tool is switched off
and unplugged or that the battery cartridge is
removed before carrying out any work on the
tool.
26. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
27. Do not use separate reducing bushings or
adaptors to adapt large hole abrasive wheels.
28. Use only flanges specified for this tool.
29. For tools intended to be fitted with threaded
hole wheel, ensure that the thread in the wheel
is long enough to accept the spindle length.
30. Check that
supported.
31. Pay attention that the wheel continues to
rotate after the tool is switched off.
32. If working place is extremely hot and humid, or
badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure
operator safety.
33. Do not use the tool on any materials
containing asbestos.
34. Do not use water or grinding lubricant.
35. Ensure that ventilation openings are kept clear
when working in dusty conditions. If it should
become necessary
disconnect the tool from the mains supply
( use non metallic objects ) and avoid
damaging internal parts.
36. When use cut-off wheel, always work with the
dust collecting wheel guard required by
domestic regulation.
37. Cutting discs must not be subjected to any
lateral pressure.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
the workpiece is
to clear dust,

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Shaft lock
1
properly
006019
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
first
003568
CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the ''O(OFF)'' position when the rear of the switch
lever is depressed.
To start the tool, slide the switch lever toward the ''I (ON)''
position. For continuous operation, press the front of the
switch lever to lock it. To stop the tool, press the rear of
the switch lever, then slide it toward ''O (OFF)'' position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
6
1. Press
1. Slide switch
1
lever