Related Manuals for Makita MGA700
Summary of Contents for Makita MGA700
- Page 1 INSTRUCTION MANUAL Angle Grinder MGA700 MGA900 006770 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model MGA700 MGA900 Depressed center wheel diameter 180 mm 230 mm Rated speed (n)/ No load speed (n 8,500 min 6,600 min Overall length 468 mm 468 mm Net weight 5.5 kg 5.8 kg Safety class •... -
Page 3: Grinder Safety Warnings
If operating a power tool in a damp location is accessories, or storing power tools. Such unavoidable, use a residual current device preventive safety measures reduce the risk of (RCD) protected supply. Use of an RCD reduces starting the power tool accidentally. the risk of electric shock. - Page 4 The rated speed of the accessory must be at or snagged and your hand or arm may be pulled least equal to the maximum speed marked on into the spinning accessory. the power tool. Accessories running faster than 12. Never lay the power tool down until the their rated speed can break and fly apart.
- Page 5 have a tendency to snag the rotating accessory and d) Do not restart the cutting operation in the cause loss of control or kickback. workpiece. Let the wheel reach full speed and e) Do not attach a saw chain woodcarving blade carefully reenter the cut.
-
Page 6: Functional Description
24. Do not touch the workpiece immediately after FUNCTIONAL DESCRIPTION operation; it may be extremely hot and could burn your skin. 25. Always be sure that the tool is switched off CAUTION: and unplugged or that the battery cartridge is Always be sure that the tool is switched off and •... - Page 7 and then pull the switch trigger (in the B direction). For tool with locking screw type wheel guard Release the switch trigger to stop. 1. Wheel guard For tool with the lock on and lock-off switch 2. Screw To prevent the switch trigger from accidentally pulled, a 3.
-
Page 8: Operation
reverse. Installing or removing depressed center grinding wheel/Multi-disc (accessory) OPERATION 1. Lock nut WARNING: 2. Depressed It should never be necessary to force the tool. The center wheel • 3. Super flange weight of the tool applies adequate pressure. 4. Inner flange Forcing and excessive pressure could cause dangerous wheel breakage. - Page 9 potential for injury from contact with broken brush Operation with abrasive cut-off / diamond wires. wheel (optional accessory) 1. Wire cup brush WARNING: When using an abrasive cut-off / diamond wheel, • be sure to use only the special wheel guard designed for use with cut-off wheels.
-
Page 10: Maintenance
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. 006779 The tool and its air vents have to be kept clean. Regularly clean the tool's air vents or whenever the vents start to... - Page 11 Side grip Wheel guard for Depressed center grinding wheel/Multi-disc / Wire wheel brush Inner flange / Super flange / Inner flange 102 (Australia and New Zealand only) Depressed center grinding wheel/Multi-disc Lock nut / Ezynut*1 Wheel guard for Abrasive cut off wheel / Diamond wheel Dust collecting wheel guard Inner flange / Super flange / Inner flange 78 (Australia and New Zealand only) Abrasive cut off wheel / Diamond wheel...
- Page 12 Makita Corporation www.makita.com 884726B0...