Cisco Aironet 1200 Series Software Configuration Manual page 147

Chapter 4 Security Setup
Table 4-5 Settings for Authentication Types
Authentication Types
LEAP
LEAP and static WEP
under 802.11 Open
EAP-TLS and EAP-MD5 On the Authenticator Configuration page (shown in
OL-2159-01
Required Settings
On the Authenticator Configuration page (shown in
Select an 802.1x protocol draft that matches the protocol draft used by
•
client devices that associate with the access point.
Enter the name or IP address, type, port, shared secret, and timeout
•
value for your RADIUS server.
Select the EAP check box under the server.
•
On the AP Radio Data Encryption page (shown in
• Select the Network-EAP check box.
Enter a WEP key in key slot 1 and select 128-bit from the key size
•
menu.
Enter all the settings for LEAP authentication.
•
On the AP Radio Data Encryption page (shown in
Select the Open check box.
•
• Select an 802.1x protocol draft that matches the protocol draft used by
client devices that associate with the access point.
• Enter the name or IP address, type, port, shared secret, and timeout
value for your RADIUS server.
• Select the EAP check box under the server.
On the AP Radio Data Encryption page (shown in
Select the Open and Network-EAP check boxes.
•
• Select the Require EAP check box under Open.
Selecting Require EAP blocks non-EAP client devices from
Note
using the access point.
• Enter a WEP key in key slot 1 and select 128-bit from the key size
pull-down menu.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Summary of Settings for Authentication Types
Figure
Figure 4-6):
Figure 4-6):
Figure
Figure 4-6):
4-13):
4-13):
4-35