Option 64 - Assemble Zone - Honeywell GX-Series Installation And Setup Manual

Option 64 – Assemble Zone
The Assemble Zones option allows 2 zone functions to be customized to the user's requirements; these are
the 1 Custom-A and 2 Custom-B zones. Once a custom zone function has been assembled, it is assigned to
zones using option 52 = PROGRAM ZONES.
Programming a Custom Zone
The flexibility of this menu option allows for an extensive range of possibilities. It is therefore important
that the engineer is fully aware of the system and has a clear picture of what is required of the new zone
function. The procedure for assembling a custom zone has 4 stages:
1. Outputs
2. Status
3. Setting (arming)
4. Log
1 = Outputs
2 = Status
3 = Setting/
arming
4 = Log
1 = Outputs
Any of the available output types can be assigned to the custom zone. On selecting this attribute the
01=BELLS output type is displayed along with it status; the default status is disabled. The status
indicates the conditions under which the custom zone activates the output. To assign the output type
status press the # key, this toggles between each of the status settings:
1. Disabled the output is not activated by the custom zone,
2. Set the output is activated by the custom zone only when the system is set (armed),
3. Unset the output is activated by the custom zone only when the system is unset (disarmed).
4. Set/Unset the output is activated by the custom zone when the system is both set (armed) and
unset (disarmed).
Select the output types to be assigned by pressing the A> and <B keys or by entering the number of the
required output type and assign the required status. When all of the output types have been selected,
press the esc key to return the previous menu level. For a full list of output types refer to option 53 =
Program Outputs.
GX-Series Control Panel Installation and Setup Guide
Output Type: Disabled Set
Unset
Set/Unset
1 = Unset Disabled
Alarm
2 = Entry/ Exit Disabled
Alarm
3 = Part Set Disabled
Alarm
4 = Full Set Disabled
Alarm
1 = Begin Set Disabled
Enabled
2 = Begin Disabled
Entry Enabled
3 = Sets Disabled
System Enabled
Disabled Entry
Exit 24 Hours
Alarms
Table 6-29. Programming a custom Zone
A/B – select output type
# – toggle between Disabled, Set,
Unset & Set/Unset
esc – save programming
# – toggle between Disabled and
Alarm esc – save programming
# – toggle between Disabled and
Enabled
esc – save programming
# – toggle between Disabled,
Entry/Exit, 24 Hours & Alarms esc –
save programming
6-117