Problems Relating To The Easy Interactive Function; Cannot The Projector's Built-In Drawing Function - Epson EB-485W User Manual

Problem Solving
Check
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cord, or the power cord may be defective. Reinsert the power cord. If this
Is the Control Panel Lock set to Full Lock?
Is the remote receiver set correctly?

Problems Relating to the Easy Interactive Function

Cannot the projector's built-in drawing function

Check
Is Extended set correctly?
Has pen calibration been performed correctly?
does not solve the problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the setting to Off.
s Settings - Control Panel Lock p.101
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.101
The projector's built-in drawing function is not available if both of the following conditions are met.
• Extended - USB Type B is set to Easy Interactive Function or USB Display/Easy Interactive Function from the
configuration menu.
• Images are projected from the source specified in Extended - Easy Interactive Function - Use Source from the
configuration menu.
s Extended-Easy Interactive Function
Make sure you perform pen calibration when using the Easy Interactive Pen for the first time so that the projector
recognizes the position of the pen correctly.
Also, calibrate the pen again if you notice any discrepancy in positioning.
s "Calibrating the pen" p.59
http://www.pureglare.com.au
Remedy
Remedy
p.103
129