Wifi Range Extender Setup - NETGEAR Trek PR2000 Instalaltion Manual

WiFi Range Extender Setup

Use the Trek as a WiFi extender to connect your wireless devices
that are outside the range of your existing WiFi router. NETGEAR
recommends that you connect to the WiFi network of the Trek when a
wireless device is in a dead zone where the connection to your
existing WiFi router is poor or nonexistent.
 To use the Trek as a WiFi range extender:
1. Place the Trek at an equal distance between your existing WiFi
router and the wireless device that is located in the dead zone of
your router.
2. Connect the Trek to a power source.
For more information, see
3. Turn on power to the Trek by moving the Internet Mode switch
from the Power Off position to the Wireless position.
4. Rotate the Trek's cover clockwise to orient the antenna.
For more information, see
Power Inputs
Antenna Orientation
10
on page 5.
on page 7.