Lint Filter; To Remove The Self-Cleaning Filters; Manual Clean Lint Filter - Maytag LAT2300 Service Manual

Manual Clean Lint Filter
LINT FILTER
Self Cleaning Filters
The system uses two self-cleaning
filters located in the bottom of the inner
tub. The filters are cleaned when the
washer goes into spin. The lint is held
on the bottom side of the filters and is
flushed down the drain with the water.
To Remove The Self-Cleaning Filters:
1. Loosen screw located on the side of
the agitator.
2. Remove agitator.
3. Pry out filter. It is held in place witt
several tabs. Grasp filter in the
center on the long side. Lift up and
push in at the same time to remove
filter.
4. Replace filter by pressing into place.
Water Saver models are equipped with
manual clean lint filters. The manual
clean lint filter (on some models) is
located in the center of the agitator.
The filter may be removed and cleaned.
Because of the effectiveness of the
draining system, normally there will be
little lint or none at all on the filter.
More lint will be collected when
washing very Iinty loads, such as
towels, rugs, and blankets.
16001145
SECTION 3. WASHER - SERVICE PROCEDURES
3-22
©1994 Maytag Corporation