Connection Via Ethernet Pc Card - Casio DT-X11M10E Quick Start Manual

5.6 Connection via Ethernet PC Card

This procedure has been tested using a SOCKET LP-E (CF card) in a CF to PCMCIA converter.
Establish Partnership.
Establish partnership first between the DT-X11 and PC via either Direct IrDA or Direct USB, or via
Bridge Satellite Cradle.
Set up Ethernet Connection on the DT-X11
1. Insert the LAN card into the PC Card slot on the DT-X11.
2. On the DT-X11, navigate to Start → Settings → Control Panel → Network and Dialup
Connections.
3. You should see NE20001 as an option. Highlight this and choose Properties from the
Connection menu.
4. Configure the settings suitably for your network.
5. On the Name Servers tab, you should enter the IP address of your PC on the Primary WINS
line.
Establish Connection to your PC
1. On the PC, make sure Allow network [Ethernet] and Remote Access Service [RAS]
server connection with this desktop computer. has been set enabled (see Figure 5.36).
Figure 5.36
2. On the DT-X11, navigate to Start → Programs → Communication → LAN ActiveSync
to initiate the connection.
3. Ensure that Network Connection is the name of the connection method and that Connect to
line is the name of your PC.
4. Tap Connect ... button and then the connection should be made.
47