Casio DT-X11M10E Quick Start Manual page 40

3. Choose Yes, I want to restart my computer now. radio button, and then click Finish
button (see Figure 5.25). Reboot your PC to set the IrXpress driver enabled.
Figure 5.25
Establish Connection to Your PC
1. On the base of the Bridge Satellite Cradle you will find a bank of DIP switches. Ensure that
switch no. 6 is in the OFF position to enable RS-232C connection. If you change the switch
settings, ensure that you power off and then on again so that the settings take effect.
2. Plug one end of the 9 pin RS-232C cable (DT-887AXA) into the Serial port on the Bridge
Satellite Cradle.
3. Plug the other end of the RS-232C cable (DT-887AXA) into the correct COM port on your PC.
4. In order to set which COM port the IrXpress driver uses on your PC, choose Wireless Link in the
Control Panel.
5. Click Hardware tab and choose CASIO IrXpress Serial Infrared from the Devices list. Click
Properties.
6. Click Advanced tab. You can now choose the physical COM port to which the cradle is
attached and maximum connection speed (set this to 115200 bps). Click OK button and then OK
button again. The connection is now ready to use.
Establish Partnership
For detailed explanation on establishing the partnership, see the procedure Establish Partnership
in Chapter 5.2.1 "Via Direct IrDA" on page 31.
40