Philips Sopho 2000 IPS User Manual page 691

(3) To provide the One Touch key to send "Hooking Signal + Called Number" to a Centrex, set the
following data in addition to the programming (2).
START
CM20 Assign the access code for sending of a Hook-
ing signal to a Centrex.
Maximum of two digits are available.
CM90 Assign a RECALL key on the D
key is used to return to a former line.
CM35 Provide Centrex trunk route with Centrex
function.
END
(4) To provide the One Touch key to send "Called Number + DTMF Signal" for such as VMS operation,
set the following data in addition to the programming (2), when the called number includes a trunk
access code. If the called number includes no trunk access code, this data is not required.
START
CM08 Specify whether to set consecutive dialing
"* #" as a delimiter between the called number
and the DTMF signal.
END
DESCRIPTION
term
. RECALL
DESCRIPTION
• Y=0-3
(1) X-XXXX: Access code
(2) A158: Hooking signal to a Centrex
• Y=00
(1) My Line No. +
(2) F1015: RECALL
• Y=86
(1) 00-63: Trunk Route No.
(2) 0: Centrex
(1) 448
(2) 0 : * # set as dialed digit
1 : Delimiter between called number and
DTMF signal
– 673 –
STATION SPEED DIALING
DATA
,
+ Key No. (90)
DATA
NWA-008845-001 Rev.5.0
32ch1010.fm