Philips Sopho 2000 IPS User Manual page 198

If required, clear the partial memory using the commands shown below.
NOTE 1: The following data assignment is required only when using PN-4RSTC as a CIR Trunk.
NOTE 2: Before memory clear, set the SW1-1 to SW1-4 on the CIR Trunk to all ON (Make-busy) and after
memory clear, restore them to OFF.
START
CMDB Clear the memory for the calling number
Development Table number assigned by
CMDC and the calling number development
data assigned by CMDB.
Clear the memory for calling number
development data assigned by CMDB.
END
(4) CALLER ID Development Data Assignment
NOTE: The following data assignment is required only when using PN-4RSTC as a CIR Trunk.
START
CMDC Assign the Development Table for the calling
number sent from the network.
CMDB Assign whether the Trunk Tenant number is
effective for developing the calling number, or
not.
By character code, assign the name displayed,
if required.
A maximum of 14 characters are available for
the name display.
A
DESCRIPTION
DESCRIPTION
• Y=91 Partial Memory Clear
(1) 0001
(2) CCC
• Y=92 Partial Memory Clear
(1) 0002
(2) CCC
• Y=00-63 Trunk Tenant No.
(1) Calling No.
(2) 0 -1499: Development Table No. 0-1499
• Y=30
(1) 0: Trunk Tenant No. Development
(2) 0 : Ignore actual Trunk Tenant and use the
Development Table for Trunk Tenant
00 (CMDC Y=00)
1 : Execute actual Trunk Tenant and use
the Development Table for each Trunk
Tenant (CMDC Y=00-63)
• Y=00 Name Assignment
(1) 0-1499: Development Table No.
(2) Character Code
See APPENDIX B:
Page B2
– 180 –
CALLER ID CLASS
DATA
DATA
Character Code Table.
NWA-008845-001 Rev.5.0
32ch1003.fm
JULY/01/2006