Table of Contents
Advertisement
CAUTION:
Be sure to tighten the hex bolt securely. Insufficient
•
tightening of the hex bolt may result in severe injury.
Use the socket wrench provided to help assure
proper tightening.
Always use only the proper inner and outer flanges
•
which are provided with this tool.
Always lower the wheel guard after replacing the
•
wheel.
Securing workpiece
1
003986
By turning the vise handle counterclockwise and then
flipping the vise nut to the back, the vise is released from
the shaft threads and can be moved rapidly in and out. To
grip workpieces, push the vise handle until the vise plate
contacts the workpiece. Flip the vise nut to the front and
then turn the vise handle clockwise to securely retain the
workpiece.
CAUTION:
Always set the vise nut to the front fully when
•
securing the workpiece. Failure to do so may result
in insufficient securing of the workpiece. This could
cause the workpiece to be ejected or cause a
dangerous breakage of the wheel.
When the cut-off wheel has worn down considerably, use
a spacer block of sturdy, non-flammable material behind
the workpiece as shown in the figure. You can more
efficiently utilize the worn wheel by using the mid point on
the periphery of the wheel to cut the workpiece.
1
003987
When cutting workpieces over 85 mm wide at an angle,
attach a straight piece of wood (spacer) to the guide plate
as shown in the figure. Attach this spacer with screws
through the holes in the guide plate.
1. Vise plate
2
2. Vise nut
3. Vise handle
3
1. Spacer block
1
2
3
003988
If you use a spacer block which is slightly narrower than
the workpiece as shown in the figure, you can also utilize
the wheel economically when worn down the wheel.
1
5
4
003989
Long workpieces must be supported by blocks of
non-flammable material on either side so that it will be
level with the base top.
1
003990
OPERATION
Hold the handle firmly. Switch on the tool and wait until the
wheel attains full speed before lowering gently into the cut.
When the wheel contacts the workpiece, gradually bear
down on the handle to perform the cut. When the cut is
completed, switch off the tool and WAIT UNTIL THE
WHEEL HAS COME TO A COMPLETE STOP before
returning the handle to the fully elevated position.
CAUTION:
Proper handle pressure during cutting and
•
maximum cutting efficiency can be determined by
the amount of sparks that is produced while cutting.
Your pressure on the handle should be adjusted to
produce the maximum amount of sparks. Do not
force the cut by applying excessive pressure on the
handle. Reduced cutting efficiency, premature
wheel wear, as well as, possible damage to the tool,
6
1. Guide plate
2. Straight piece of
wood (Spacer)
3. Over 85mm long
1. Diameter of
workpiece
2
2. Guide plate
3. Spacer block
3
4. Width of spacer
block
5. Vise
1. Blocks
1
Advertisement
Table of Contents
