Table of Contents
Advertisement
ENGLISH (Original instructions)
SPECIFICATIONS
No load speed (min
Dimensions (L x W x H)
Net weight
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for cutting in masonry and ferrous
materials with appropriate abrasive cut-off wheel. Follow
all laws and regulations regarding dust and work area
health and safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
Model
Wheel diameter
Hole diameter
-1
)
With full type lower safety guard
With half type lower safety guard
With center cover/center cap
Safety class
equipment
END201-5
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.31 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
SAFETY INSTRUCTIONS
WARNING! When using electric tools, basic safety
precautions, including the following, should always
be followed to reduce the risk of fire, electric shock
and personal injury. Read all these instructions
and
its
before operating this product and save these
instructions.
For safe operations:
1.
Keep work area clean.
Cluttered areas and benches invite injuries.
2.
Consider work area environment.
Do not expose power tools to rain. Do not use
ENE007-2
power tools in damp or wet locations. Keep work
area well lit. Do not use power tools where there is
risk to cause fire or explosion.
3.
Guard against electric shock.
Avoid body contact with earthed or grounded
surfaces
ENF002-2
refrigerators).
4.
Keep children away.
Do not let visitors touch the tool or extension cord.
All visitors should be kept away from work area.
5.
Store idle tools.
When not in use, tools should be stored in a dry,
ENF100-1
high or locked up place, out of reach of children.
6.
Do not force the tool.
It will do the job better and safer at the rate for
which it was intended.
2
MLC140
355 mm
25.4 mm
3,800
500 mm x 280 mm x 620 mm
17.8 kg
16.7 kg
15.4kg
/II
(e.g.
pipes,
radiators,
ENA001-2
ranges,
Advertisement
Table of Contents
