Cisco TelePresence EX Series Getting Started Manual page 27

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Web interface
Configuring H.323 and SIP
(when not set by a provisioning system)
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use either
the H.323 protocol or the SIP protocol for video calls.
NoTE: Contact your system administrator, or service
provider, for information about the network settings.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite) your Cisco TMS
administrator will help you to get online.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
H.323
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the Configuration tab and select
Configuration.
Open the H323 settings from the left column.
2. Under the H323 Alias heading, enter the
number in their respective input fields.
3. Go to the Gatekeeper heading.
If you want the system to obtain the H.323 gatekeeper
address automatically, select
down list; if you want to enter the address manually,
select Manual.
If set to Manual enter the gatekeeper
corresponding input field. Click
4. If the H.323 gatekeeper requires authentication and
you want your system to authenticate itself to the
gatekeeper, go to the Authentication
select On in the Mode drop down list. Then enter the
LoginName and Password in the corresponding input
fields. Click ok to save the change.
Otherwise, select Off in the Mode
5. Go to the Diagnostics tab and select
to verify the H323 settings.
If you successfully registered to a Gatekeeper the
will show Registered in the H323 section.
Please check the Administrator guide for your product if you
want to change the other H.323 settings.
Appendices
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
Advanced 1. Go to the
Configuration.
Open the
ID and E164 2. Enter the SIP URI in the
display name in the
save the change.
3. Select the preferred transport protocol from the
DefaultTransport
Auto in the Discovery drop
system will first try to connect using TLS, then TCP, and
finally UDP.
Address in the 4. Select a proxy type in the
ok to save the change. default type is Standard.
5. Go to the
If you want the system to obtain the SIP proxy address
heading and
automatically, select
list; if you want to enter the address manually, select
Manual.
If you select
drop down list.
corresponding input field. Click
System Information
6. If the SIP proxy requires authentication you must enter a
login name and password to authenticate your system.
Status Go to the
LoginName
fields. Click
7. Go to the
to verify the SIP settings.
If you successfully registered to a SIP server the
will show
Please check the Administrator guide for your product if you
want to change the other SIP settings.
Configuration tab and select Advanced
SIP page from the sidebar on the left.
URI 1 input field, and optionally a
DisplayName input field. Click ok
drop down list. If you select Auto, the
Type drop down list. The
Proxy 1 heading.
Auto in the Discovery drop down
Manual enter the proxy Address in the
ok to save the change.
Authentication 1 heading and enter the
and Password in the corresponding input
ok to save the change.
Diagnostics tab and select System Information
Status
Registered in the SIP section.
www.cisco.com
27
to