Cisco TelePresence EX Series Getting Started Manual page 15

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
touch controller
Configuring H.323 and SIP
(when not set by a provisioning system)
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use either
the H.323 protocol or the SIP protocol for video calls.
NoTE: Contact your system administrator, or service
provider, for information about the network settings.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite) your Cisco TMS
administrator will help you to get online.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
H.323
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Tap More > Settings > Administrator Settings > Network
Settings > H323 Settings
2. Enter the H323 Number and
input fields.
3. If you want to enter the address of the H.323 gatekeeper
manually, tap Manual in the Gatekeeper Discovery
section, and enter the Gatekeeper Address
field. Otherwise tap Auto.
4. If the H.323 gatekeeper requires authentication and
you want your system to authenticate itself to the
gatekeeper, tap ON in the Authentication Mode
and enter the Login Name and
respective input fields. Otherwise, tap OFF.
5. Tap Save to save the changes, or
saving.
6. Tap Back twice to review the System Information page
and verify the H323 settings.
If you successfully registered to the Gatekeeper the
Status will show Registered in the H323 section.
7. Tap Exit to return to the home menu.
Appendices
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Tap
Settings > SIP Settings
H323 Id in their respective 2. Enter the SIP URI in the
3. Tap the preferred transport protocol in the
Transport
try to connect using TLS, then TCP, and finally UDP.
in the input
4. Select a
proxy types by tapping the - or + signs. The default type
is Standard.
5. If you want to enter the SIP proxy address manually, tap
section
Manual
Password in their
Proxy Address
to obtain the SIP proxy address automatically (DHCP),
Undo to leave without tap Auto.
6. If the SIP proxy server requires authentication you must
enter the
input fields to authenticate your system.
7. Tap
saving.
8. Tap
and verify the SIP settings.
If you successfully registered to a SIP server the
will show
9. Tap
More > Settings > Administrator Settings > Network
URI input field.
Default
section. If you select Auto, the system will first
Proxy Type. Step through the list of available
in the Proxy Discovery section and enter the
in the input field. If you want the system
Login Name and Password in their respective
Save to save the changes, or Undo to leave without
Back twice to review the System Information page
Registered in the SIP section.
Exit to return to the home menu.
www.cisco.com
15
Status