Enabling Power Save Mode; Disabling Power Save Mode - Epson S1D13706 Technical Manual

Page 28

5.3 Enabling Power Save Mode

5.4 Disabling Power Save Mode

S1D13706
X31B-G-003-03
Power Save Mode must be enabled using the following steps.
1. Disable the LCD bias power using GPO.
Note
The S5U13706B00C uses GPO to control the LCD bias power supplies. Your system
design may vary.
2. Wait for the LCD bias power supply to discharge. The discharge time must be based
on the time specified in the LCD panel specification.
3. Enable Power Save Mode - set REG[A0h] bit 0 to 1.
4. At this time, the LCD pixel clock source may be disabled (Optional).
5. Optionally, when the Memory Controller Power Save Status bit (REG[A0h] bit 3)
returns a 1, the Memory Clock source may be safely shut down.
Power Save Mode must be disabled using the following steps.
1. If the Memory Clock source is shut down, it must be started and the Memory Control-
ler Power Save Status bit must return a 0. Note if the pixel clock source is disabled,
it must be started before step 2.
2. Disable Power Save Mode - set REG[A0h] bit 0 to 0.
3. Wait for the LCD bias power supply to charge. The charge time must be based on the
time specified in the LCD panel specification.
4. Enable the LCD bias power using GPO.
Note
The S5U13706B00C uses GPO to control the LCD bias power supplies. Your system
design may vary.
Epson Research and Development
Vancouver Design Center
Programming Notes and Examples
Issue Date: 01/02/23