Installation; Setting Up Your Telephone - AEG Corded Telephone Style 15 Quick Start Manual

6
6

INSTALLATION

1. Locating the base unit (see P3 and P4)
The base unit should be placed on a level surface, in a position where:
The mains adapter plug will reach an easily accessible 220 - 230-V AC switched mains supply socket
- never try to lengthen the mains power cable.
The telephone line cable will reach your telephone line socket or extension socket.
It is not close to a sink, bath or shower, or anywhere else where it might get wet.
It is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs,
fluorescent lights, etc.
2. Plug the coiled handset cord into the handset. Plug the other end into the jack on the side of the
base unit.
3. Place the handset on the base unit.
4. Plug the telephone line cord into the phone line jack at the back of the base unit. Plug the other
end into your telephone line socket or extension socket.
5. Plug the power supply cord into the power jack at the back of the base unit. Plug the other end into
a 220 - 230 V AC, 50 Hz mains socket.
6. Wait while the display shows "INITIALIZATION ", then the announcement "Answering machine on.
Announcement one." before the display changes to the standby screen.
7. Lift the handset and check for dial tone.
Note:
The base unit doesn't require a battery.
Always use the telephone line cord supplied with your phone. Other telephone line cords may not
work.
7

SETTING UP YOUR TELEPHONE

The following section details how to set up your telephone. Press the menu button
options menu and then use the up
Note:
The system will time out if you leave more than 10 seconds between key presses.
7.1 Set language
With the phone in standby mode;
Press the menu button
>The display shows "OPTIONS MENU".
Press the up button
>The display shows "SET LANGUAGE".
Press the OK button
Press the up or down
Press the OK button
Continue with programming, or press the stop button
or down
.
to go to the language setting.
to confirm.
button to select "ENGLISH" (default), "FRANCAIS" or "DEUTSCH".
to confirm.
buttons to cycle through the options:
to return to standby mode.
to enter the