Table of Contents
Advertisement
Contents of the packing
• 1 base
• 1 handset
• 1 cable for the handset
• 1 telephone line cord
• 1 support for wall mounting / cable canal cover
• Material for wall mounting (dowels, screws)
• 1 manual
Specific features
• Re-dialing of the last number dialed
• Re-dialing with pause
• Volume of the ringer selectable in 3 levels
• Table appliance (possibility of wall mounting)
• Can be used in connection with a switchboard
• Tone or pulse dialing – Flash-time adjustable
• Mute (microphone switched off)
• 3 memories for shortcut dialing M1-M3, 10 indirect memories 0-9
Installation of the appliance
The appliance leaves the factory in the configuration for table use. For access-
ing the cable canals and the inlets, the cover (K, Fig.2, page 4) must be re-
moved. Therefore, slide the unlocking bolt (L) up and take off the cover.
1.
Use the telephone line cord to realize the connection between the tele-
phone outlet and the connection (G) at the bottom of the base. Place the
cord in the cable canal (I).
2.
Connect the handset cable to the inlet (D) of the base (A) and to inlet (C) of
the handset (B). Place the cord in the cable canal (J).
Put the cover back as it was at delivery for using the appliance as a table tele-
phone. If you want to mount the appliance to a wall, proceed as follows:
1.
Drill two 6 mm holes at a vertical distance of 90 mm. Put the dowels in the
holes and screw in the delivered screws. Bring the screws to a depth so
that the distance between the all and the head of the screw is 5 to 7 mm.
2.
Fit the cover to the wall in the reverse direction (see Fig.3, page 4). Hang
the telephone in both screws and slide it down, until it is well fixed and no
longer wobbles.
3.
Pay attention to the slide switch for the ringer volume. This is sitting on the
bottom of the base. Adjust the volume of the ringer before mounting the
appliance to the wall.
6
AEG Milano 10_en
Advertisement
Table of Contents
