How To Part Set The System - Honeywell Accenta User Manual

How to Part Set

How to Part Set the System

If your installer has programmed your system for part set operation you will be able to set some zones of the
system while others remain unset. Part set operation is often used at night time, and it will permit you to freely
walk around the bedrooms while the living area and outside doors are protected. Your system may have 2
part-set programs called Program 2 and Program 3.
Before part-setting the system you should ensure that all doors and windows are closed. Ensure that pets do
not have access to the protected areas. Your installer may have instructed you to use a different keypad to the
one normally used to set the system.
LCD Keypad:
• The Day LED should be on. The screen shows the Day
mode:
• Enter your code [0][1][2][3]. The exit beep starts.
• Press the [PROG] key. The exit tone stops.
• Select part-set program [2] or [3]. The system will set after a
short time. The Day LED goes out.
NOTE: There will be no exit beeps if Silent Timed exit mode was
programmed.
Accenta/Optima User Guide
Sunday
Program 1 Set Program 1 Set
Program 1 Set Program 1 Set Program 1 Set
Set System Set System
Set System Set System Set System
Select 1 2 or 3 Select 1 2 or 3 Select 1 2 or 3 Select 1 2 or 3 Select 1 2 or 3
** SYSTEM SET ** ** SYSTEM SET ** ** SYSTEM SET ** ** SYSTEM SET ** ** SYSTEM SET **
S u n d a y
S u n d a y S u n d a y
4
01-Jan
Power
14:10
[4-digit code]
[PROG]
[2 or 3]
S u n d a y 0 1 - J a n 0 1 - J a n
S u n d a y 0 1 - J a n 0 1 - J a n 0 1 - J a n
14:10 14:10 14:10 14:10 14:10
Day