Selecting A Radio Station; Storing Radio Stations (Preset); Tuning In To A Preset Radio Station - JVC UX-QD90S Instructions Manual

(Continued)
Listening to Radio Broadcasts

Selecting a Radio Station

1
Press to select "FM" or "AM".
Example: While an FM radio broadcast is
received
Stereo indicator Preset number (
Frequency
2
Press or
select a radio station (frequency).
• You can also select a radio station using the
automatic tuning.
Automatic tuning:
Hold down or
quency starts changing, and then release
the button.
When the main unit has received a broad-
cast, the frequency automatically stops
changing.
To quit the function while searching for a
broadcast, press
• When the main unit has received an FM
stereo broadcast, "STEREO" lights up.
Switching the FM reception (stereo/
monaural):
If an FM stereo broadcast is difficult to hear
because of noise, you may be able to hear
more easily by pressing
the sound to monaural reception. In this
case, "MONO" lights up. To return the sound
to stereo reception, press
21
on the right)
repeatedly to
until the fre-
or .
to switch
again.
For the locations of remote control
buttons, refer to page 20.

Storing Radio Stations (Preset)

You can store up to 30 FM radio stations and up to
15 AM radio stations.
■While the broadcast from the radio station
you want to preset is being received
1
Set the remote control mode
selector to AUDIO.
2
Press .
• The preset number flashes for approxi-
mately 5 seconds.
3
While the preset number is flash-
ing, press the number buttons
( - or
set number you want to use.
• Refer to "Using the number buttons"
( page 16).
• You can also select the preset number by
pressing or
4
While the selected number is
flashing, press
• "STORED" appears and the selected radio
station is stored.
NOTE
• The type of FM reception (stereo/monaural) is also
( on the left).
stored
• When you store a radio station to a preset num-
ber to which another radio station has previously
been stored, the newly set radio station replaces
the previously stored radio station.

Tuning In to a Preset Radio Station

■While an FM or AM broadcast is being received
1
Set the remote control mode
selector to AUDIO.
2
Use the number buttons to select
the preset number of the radio sta-
tion to which you want to tune in.
• Refer to "Using the number buttons"
( page 16).
• You can also select the preset number by
pressing or
Introduction
) to select the pre-
.
or .
.