Operating The Tv Using The Remote Control - JVC UX-QD90S Instructions Manual

This page is for when operating your TV using
the remote control of this product.
Operating the TV Using the
Remote Control
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Hold down
Hold down until step 4 is completed.
3
Press and release.
4
Press number buttons (
Remote control
mode selector
Number buttons
.
- , ).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are two or more manufacturer's codes, try
them in turn and select the one that enables the
product to work properly.
Manufacturer Code
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
Philips 14
RCA 05
5
Release .
NOTE
• The manufacturer's codes may be changed without
notice. You may not be able to operate a TV
produced by the manufacturer shown above.
For TV operation
Operate the remote control by pointing it towards
the TV.
Turn on/off the power.
Change channels.
Adjust volume.
- /
/
Change between the previously
selected channel and the cur-
rent channel.
Change between TV and video
input.
*1 Make sure to slide the remote control mode selector
to the TV side in advance.
NOTE
• When the batteries are replaced, perform the man-
ufacturer's code setting again.
Manufacturer Code
Samsung 12
Sanyo 13
Sharp 06
Sony 07
Toshiba 08
Zenith 09
Select channels.
*1
10