Makita DVC340 Instruction Manual page 8

Vacuum Cleaner
011122
When using the cleaner as a portable cleaner,
cross-hanging the shoulder strap before the breast is
difficult to drop the cleaner.
1
2
4
5
011123
NOTE:
Long cut-off decorative paper that may be
•
produced by plaster board cutting work depending
on the conditions of workpiece to be cut and that
may be stuffed inside the hose may cause the hose
suction blocking. When this occurs, change the
cutting depth setting of power tool to deeper depth,
which will relieve the hose suction blocking.
CAUTION:
When the dust bag is just new, dust may come out
•
of its surface. Using it a few times will minimize the
dust leak from the surface.
1. Decorative
paper
2. Saw blade
3. Base
4. Cutting depth
5. Plaster board
3
Operation of the cleaner with a nozzle or a
dust bag being installed
WARNING:
Always be sure that the cleaner is switched off
•
and the battery cartridge is removed before
installing or removing the nozzle or any other
attachment on the cleaner. Failure to switch off
and remove the battery cartridge may result in
serious personal injury.
NOTE:
Before the blower mode operation immediately
•
after the cleaner mode operation, remove all
remaining dust from the cleaner due to possible
blow out of dust .
Using as a blower
1
011124
Install the nozzle onto the outlet (air vent) without fail.
To install the nozzle, fit the pin protruding from the inside
of nozzle to one of the cleaner notches and then turn
the nozzle clockwise securely.
To remove the nozzle, turn counterclockwise and pull it
out.
Direct the top point of the cleaner and then switch on.
Emptying the dust bag
WARNING:
Always be sure that both the cleaner and a
•
connected power tool are switched off and the
battery cartridge is removed and
tool, if corded tool, is unplugged before
installing or removing the dust bag on the
cleaner and emptying the dust bag( made of
cloth). Failure to switch off, remove the battery
cartridge and unplug the connected power tool may
result in electric shock and serious personal injury.
When the dust bag is about half full, remove the
•
dust bag from the cleaner and pull the fastener out.
Empty the dust bag of its contents, tapping it lightly
so as to remove particles adhering to the insides
which might hamper further collection.
8
1. Outlet (air vent)
2
2. Nozzle
3. Pin
3
the power