Makita DVC340 Instruction Manual page 6

When the remaining battery capacity gets low:
•
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, remove the battery
cartridge from the cleaner and charge it.
NOTE:
This temperature-sensitive protection is applied
•
only when the cleaner is used with a battery
cartridge with a star mark.
1
011389
Switch action
2
011121
To start the cleaner, simply press the "HIGH/LOW" button.
To switch off, press the "OFF" button. To change the
cleaner speed, press the "HIGH/LOW" button. The first
press on this button is for high speed and the second
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
ASSEMBLY
CAUTION:
Always be sure that the cleaner is switched off and
•
the battery cartridge is removed before carrying out
any work on the cleaner.
Any work with the battery cartridge being installed
•
on the cleaner may cause a personal injury or
damage to the objects around the cleaner.
1. Star mark
1. HIGH/LOW
1
button
2. OFF button
Installing dust bag
2
1
1. Dust outlet
2. Dust bag joint
3. Pins
4. Dust bag
011113
Hold the square section of the dust bag joint and fit the
pins inside the dust bag joint to the notches in the dust
outlet of the cleaner and then insert and turn it clockwise
all the way until it stops.
011114
At this time, make sure that the fastener part on the dust
bag faces upward.
NOTE:
When the dust bag joint and the ring inside the dust
•
bag come off, install as follows.
(1) Align the dust bag joint with the seam of the
dust bag and install it so that its protrusion
faces upward.
011115
(2) Tighten the ring inside the dust bag firmly so
that the pins and the ring are positioned as
shown in the figure.
6
3
4
1. Hook
1
1. Protrusion
1