Specifications - Makita UH4261 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbol
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Do not expose to rain.
･
Remove
immediately if the cable is damaged or
cut.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for trimming hedges.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Model
Blade length
-1
)
Overall length
Net weight
Safety class
plug from the
equipment and
UH4261
420 mm
1,600
821 mm
2.9 kg
END220-4
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.1 dB(A)
mains
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : hedge trimming
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
its
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENE014-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENF002-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
UH4861
480 mm
1,600
871 mm
3.0 kg
/II
) : 82 dB(A)
pA
) : 93 dB(A)
WA
Wear ear protection
2
) : 6.7 m/s
h
2
UH5261
520 mm
1,600
921 mm
3.0 kg
ENG905-1
ENG900-1
ENG901-1