Makita UH4570 Instruction Manual
Hide thumbs
Also See for UH4570:
- Instruction manual (65 pages) ,
- Technical information (7 pages) ,
- Instruction manual (61 pages)
Related Manuals for Makita UH4570
Summary of Contents for Makita UH4570
-
Page 1: Hedge Trimmer
INSTRUCTION MANUAL Hedge Trimmer UH4570 UH5570 UH6570 009277 DOUBLE INSULATION IMPORTANT: Read Before Using. -
Page 2: Specifications
European Standard and can, therefore, also be used from sockets ENH021-4 without earth wire. For European countries only EC Declaration of Conformity Makita Corporation responsible manufacturer declare that the following Makita machine(s):... - Page 3 Designation of Machine: Keep children and bystanders away while Hedge trimmer operating a power tool. Distractions can cause Model No./ Type: UH4570, UH5570, UH6570 you to lose control. Specifications: see "SPECIFICATIONS" table. Electrical safety are of series production and Power tool plugs must match the outlet. Never Conforms to the following European Directives: modify the plug in any way.
-
Page 4: Hedge Trimmer Safety Warnings
15. Do not overreach. Keep proper footing and 27. Keep handles dry, clean and free from oil and balance at all times. This enables better control grease. GEB041-6 of the power tool in unexpected situations. 16. Dress properly. Do not wear loose clothing or HEDGE TRIMMER SAFETY jewellery. -
Page 5: Functional Description
Work gloves of stout leather are part of the basic FUNCTIONAL DESCRIPTION equipment of the hedge trimmer and must always be worn when working with it. Also wear sturdy shoes with anti-skid soles. CAUTION: 12. Before starting work check to make sure that the Always be sure that the tool is switched off and •... - Page 6 Far area cut 009282 To trim the hedge in far area with both hands pull the switch triggers A and C. ASSEMBLY CAUTION: Always be sure that the tool is switched off and • unplugged before carrying out any work on the tool. Engage the extension cord CAUTION: Make sure that the extension cord is unplugged to...
-
Page 7: Operation
Arm cord hook (Accessory) CAUTION: Do not attach the holder of arm cord hook to other • than the extension cord. Do not attach it in a position closer to the tool beyond the hook complete hooks. Failure to do so may cause an accident or personal injury. - Page 8 Installing or removing chip receiver (accessory) CAUTION: Always be sure that the tool is switched off and • unplugged before installing or removing chip receiver. NOTE: When replacing the chip receiver, always wear • 009286 gloves so that hands and face does not directly Attaching the chip receiver (accessory) on the tool when contact the blade.
-
Page 9: Maintenance
Removing or installing shear blade 1. Press the hooks on both sides CAUTION: 2. Unlock the Before removing or installing shear blade, always • hooks be sure that the tool is switched off and unplugged. When replacing the shear blade, always wear •... - Page 10 Take out the blade cover from the old shear blades and 1. Crank fit it onto the new ones for easy handling during the replacement of blades. 009298 Remove two screws from the shear blades and the shear blade unit will be taken out. 009302 1.
- Page 11 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Blade cover • Hook complete • Shear blade assembly •...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884840E228...