Samsung DCS Manual page 54

3.43 PROGRAMMING THE SMDR REPORT FORMAT
Allows the System Administrator to select the information printed on the SMDR report. The following
options may be selected to print on SMDR:
0. PAGE HEADER
1. LINE PER PAGE
2. INCOMING CALL
3. OUTGOING CALL
4. AUTHORISE
CODE
5. LESS START
TIME
6. IN/OUT GROUP
7. DND CALL
8. WAKE-UP CALL
9. DIRECTORY
NAME
10. CLIP
11. ABANDON CALL
DCS70 12. NO. OF DIAL
DCS24 MASK
Later
DCS
DCS 12 DID NUM/NAME
Page 45
This option determines whether a page header will print at the
top of each page. This would normally be turned off if SMDR
is being sent to a call accounting machine.
This option selects the length of each page to determine
when to print the SMDR header. The number of lines may be
in the range 01-99.
This option determines whether incoming calls will print on
SMDR.
This option determines whether outgoing calls will print on
SMDR.
This option determines whether authorisation codes will print
on SMDR.
This option determines whether valid calls will include the
minimum call time in total call duration.
This option allows a message, IN GROUP or OUT GROUP,
to be printed in the Digits Dialled column each time a station
enters or leaves a group.
This option allows a message, IN DND or OUT DND, to be
printed in the Digits Dialled column each time a station enters
or leaves DND.
This option determines whether stations receiving an alarm
reminder call will print on SMDR.
This option allows the System Administrator to enter a 16
character name which will appear on the SMDR header.
This option can be selected to print CLIP data received from
the CO on incoming ISDN calls. This option requires the use
of a 132 column printer or an 80 column printer set for
condensed print.
If this option is set to YES unanswered calls will print on
SMDR.
Determines if number of masked dial digits print on SMDR
If this option is set to YES the DID number and name will print
on SMDR in the Outgoing call number field.