Hanger (Suspension Point) - Makita DUR182L Instruction Manual

OPERATION
Correct handling of tool
Attachment of shoulder harness
1
2
014156
Put the shoulder harness on. Then connect the buckles
on both the hook and the harness. Be sure that the
buckles click and lock completely in place.
Only for model DUR183L
014165
When the cap is not in use, hang it on the hook.
Detachment
1
014157
The buckle is provided with a means of quick release.
Simply squeeze the sides and the buckle to release the
tool.
WARNING:
Be extremely careful to maintain control of the
•
trimmer at all times. Do not allow the trimmer
to be deflected toward you or anyone in the
work vicinity. Failure to keep control of the
trimmer could result in serious injury to the
bystander and the operator.
1. Buckle
2. Hook
1. Cap
1
1. Buckle
Adjustment of the hanger position and shoulder
harness
014164
To change the hanger position, loosen the hex bolt on
the hanger with the supplied wrench. Then move the
hanger.
After adjusting the hanger position, tighten the hex bolt
with the wrench securely.
MAINTENANCE
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
attempting
maintenance on the trimmer. Failure to switch
off and remove the battery cartridge may result in
serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
Use only 2.0 - 3.0 mm (0.08" - 0.12") diameter
•
nylon cord. Never use metal wire, rope or the
like. Use
recommended nylon cord may cause damage to
the trimmer and result in serious personal injury.
013822
12
1. Hex bolt
1
to perform inspection
of something other
or
than the