Table of Contents
Advertisement
Tighten the machine screws completely to secure the back box to the ceiling.
–
Figure 8
Surface Installation
Apply power to the camera. The camera will complete a configuration sequence: the green LED flashes five times per
Step 6
second for approximately two minutes and then turns solid after the sequence is complete.
Note
If the camera is not connected to a Dynamic Host Configuration Protocol (DHCP) server and DHCP is enabled,
the configuration sequence might take up to five minutes to complete.
Step 7
Position the camera
a. View the camera image using the service port or a Web browser.
b. Unlock the tab locks located on each side of the camera.
c. Manually rotate and tilt the camera module to position the camera. Do not over-rotate the module.
d. Lock the tab locks to secure the camera.
Figure 9
Positioning the Camera
2
4
3
1
1
Tilt 180°
Pan 355°
2
Rotate 220°
3
Tab lock
4
6
Advertisement
Table of Contents
