Installation; Back Box And Lens - Cisco 5010 Quick Start Manual

Reset Button: Reboots the camera or restores the camera's factory default settings. This button
1
is recessed. Use a small tool or a paper clip to press and release the reset button once to reboot
the camera. Press and hold the reset button for 10 seconds to restore the camera to the factory
default settings.
Micro SD Card Slot: Saves a snapshot image to a micro SD card based on alarm activity.
2
Power LED: Glows solid amber and then glows solid green during and after the configuration
3
sequence. The LED can be disabled through the user interface. If this LED glows red (solid or
flashing), contact technical support for assistance.
4 Lens Mount: Fits a standard CS-mount lens. Use a megapixel lens with the ID Series and
IDE Series megapixel cameras. A standard definition lens installed on a megapixel camera will
limit the resolution of the camera and create poor image quality.
5 Auto Iris Lens Connector: Controls the auto iris lens. Insert the 4-pin connector from the DC
drive auto iris lens into this connector.
NTSC/PAL Button: Toggles the service port between NTSC and PAL formats. The default
6
setting is NTSC.
Service Port: Outputs analog video. Use this port at the installation site to set up the field of
7
view and to focus the camera. When a service cable is connected to the camera, video to the
IP stream is disabled.
Auto Back Focus Button: Sets the auto back focus mechanism. Press the button once to center
8
the auto back focus mechanism and to fully open the iris. Press and hold the button for three
seconds to start the auto back focus mechanism and focus the camera.
Ethernet Activity/Link LED: Flashes green to indicate that data is being transmitted/received
9
by the camera. Glows solid amber to indicate that a live connection is established.
2

Installation

Back Box and Lens

For detailed instructions, refer to the user guide.
Warning Remove the foam insert from the back box before installing the system. The foam insert secures the tilt ring to
prevent damage to the optical chassis during shipment.
Megapixel lenses are designed and tested to deliver optimal image quality to the megapixel camera. A standard
Note
definition lens installed on a megapixel camera will limit the resolution of the camera and create poor image quality.
Prepare the mounting surface using one of the following options:
Step 1
• In-Ceiling Installation
Cut a 6-inch diameter hole in the ceiling.
–
Pull all wiring through the hole and terminate all wires (if not already terminated).
–
• Surface Installation
Using the surface mount ring as a template, drill holes for the mounting hardware.
–
Drill a hole in the ceiling for wiring; pull all wiring through the hole and terminate all wires (if not already
–
terminated).
Attach the surface mount ring to the mounting surface.
–
3