Cisco TelePresence System Codec C90
Contents
Introduction
xCommand Preset Clear
Delete an existing preset.
Requires user role:
USER
Parameters:
PresetId(r): <1..15>
Example:
xCommand Preset Clear PresetId:3
OK
*r PresetClearResult (status=OK):
** end
D14641.06
Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API
xConfiguration
The Provisioning commands
xCommand Provisioning StartUpgrade
xCommand Provisioning CompleteUpgrade
xCommand Provisioning CancelUpgrade
98
xCommand
xCommand
The codec software can be upgraded from the provisioning server. When starting the upgrade the
software is automatically downloaded and installed. A reboot of the codec is required to complete the
software upgrade.
AutoComplete On: The software upgrade is automatically completed, with a reboot of the codec.
AutoComplete Off: The software upgrade is not completed, and must be completed by running the
xCommand Provisioning CompleteUpgrade command.
Requires user role:
USER
Parameters:
AutoComplete: <On/Off>
Example:
xCommand Provisioning StartUpgrade AutoComplete:On
*r StartUpgradeResult (status=OK):
** end
Completes the software upgrade. This will reboot the codec. NOTE: This command is required if the
xCommand Provisioning StartUpgrade has been run with the AutoComplete set to Off.
USER
Requires user role:
Parameters:
None
Example:
xCommand Provisioning CompleteUpgrade
*r CompleteUpgradeResult (status=OK):
** end
Cancel a software update in progress.
USER
Requires user role:
Parameters:
None
Example:
xCommand Provisioning CancelUpgrade
*r CancelUpgradeResult (status=OK):
** end
API Reference Guide
xStatus
Appendices
www.cisco.com