Xstatus Audio Module [0] Connector; Xstatus Audio Module [0] Hardwareid; Xstatus Audio Module [0] Softwareid; Xstatus Audio Module [0] Type - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction
xStatus Audio Output RemoteOutput [1..n] Input [1..n] Gain
Shows the gain (dB) on the input, when input is connected to the remote output. Range from -54 dB
to 15 dB, where -54 dB equals Off.
You can run the command xStatus Audio Output RemoteOutput to find the identity [1..n] of the output
and input.
Value space of the result returned:
<-54..15>
Example:
xStatus Audio Output RemoteOutput 9 Input 1 Gain
*s Audio Output RemoteOutput 9 Input 1 Gain: 0
** end

xStatus Audio Module [0] Type

Shows the audio module type. If the module type is DigitalNAM (Digital Natural Audio Module) you can
also read the SoftwareId and HardwareId.
Value space of the result returned:
<DigitalNAM/Unknown>
Example:
xStatus Audio Module 0 Type
*s Audio Module 0 Type: DigitalNAM
** end

xStatus Audio Module [0] SoftwareID

Shows the SoftwareID of the DNAM dsp software.
Value space of the result returned:
<S: 0, 255>
Example:
xStatus Audio Module 0 SoftwareID
*s Audio Module 0 SoftwareID: "114"
** end

xStatus Audio Module [0] HardwareID

Shows the DNAM HardwareID.
Value space of the result returned:
<S: 0, 255>
Example:
xStatus Audio Module 0 HardwareID
*s Audio Module 0 HardwareID: "B40F69"
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xStatus Audio Module [0] Connector

117
xCommand
Shows which audio output connector the audio module is attached to.
Value space of the result returned:
<Line_out.1/Line_out.3>
Example:
xStatus Audio Module 0 Connector
*s Audio Module 0 Connector: "Line _ out.1"
** end
API Reference Guide
xStatus xStatus Appendices
www.cisco.com