Others; Schedule - Sony DynaView SSC-CR441 Operating Instructions Manual

OTHERS

SCHEDULE

Main menu → :OTHERS: menu
→ :SCHEDULE: menu
Tour A, B, C, FRAME scan, RANDOM
scan, and AUTO scan mode are available
for the schedule function when each status
setup is set to SCHEDULE in TOUR &
SCAN configuration.
The schedule can be configured with
individual start time and end time in a day.
If the same time is set to the start time and
the end time, the action mode will be
ignored in the schedule of the day.
The action of schedule has priority of over
the operation from user, so the action will
start at once when the start time comes.
With exception of the priority of the action,
the action of schedule will not start until the
prior action is stopped expressly, which is
activated by using the shortcut key.
Tips
The Start and End time setup is based on
hours and minutes. If it is needed same
actions in a day, it is available for same
preset position setting in tour A to C and
changing each tour's time.
Tour D and E are available only for
ALWAYS mode, not for SCHEDULE
mode.
Set the Schedule Mode
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :OTHERS:, and then press
the OPEN key to enter the :OTHERS:
menu.
3
Highlight :SCHEDULE:, and then
press the OPEN key to enter.
4
Highlight WEEK, press the OPEN
key to enter and move the joystick up/
down to select the week. Then press
the CLOSE key to confirm and quit
the menu.
5
Highlight ENABLE, press OPEN to
enter and move the joystick up/down
to select ON or OFF.
6
Press the OPEN key to enter the start
time and end time. If the end time is
same as start time, it will not be started
in the schedule.
7
Move the joystick up/down/left/right
to select the desired settings.
8
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
41
OTHERS