Sync Lock; Privacy Area - Sony DynaView SSC-CR441 Operating Instructions Manual

SYNC LOCK

The camera can use the power frequency as
the source of synchronous signal
• Signal sync can be set to Line Lock (LL)
or INT.
• The setting range of sync lock phase is
approximately 40° - 250°, and it is
divided by 100 steps.
Set the Sync Lock
Main menu → :CAMERA SETUP:
menu
→ :OTHERS: menu
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :CAMERA SETUP:, and
then press the OPEN key to enter the
:CAMERA SETUP: menu.
3
Highlight :OTHERS:, and then press
the OPEN key to enter the LINE
LOCK selection.
4
Highlight the desired option, and then
press the OPEN key to enter.
5
Move the joystick up/down to choose
the appropriate setting.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
Note
When you select the line lock mode to start,
the screen will jitter for a few seconds. This
condition is normal.

PRIVACY AREA

This feature can enable the user to black out
(or white out) a specific portion of the
screen to protect the necessary privacy. The
size and position of these frame areas can be
adjusted according to the horizontal pan,
vertical tilt, and lens zoom of the camera.
Up to 8 frame zones can be configured.
Notes
• Face the camera to the position where
you want to set a privacy mask using the
joy stick on the screen before setting.
• The mask cannot be set if the camera is
tilted between 0°and 25°.
• If you change the direction of the camera,
the mask may not cover the object
properly. Ensure the privacy masking
area is sized sufficiently beforehand.
• The privacy mask area is a rectangle that
is specified with respect to the center of
the camera image. The privacy mask may
not be set in areas close to the end of tilt
operation.
Privacy Mask Setting Range
The setting range of the privacy mask is
limited as follows:
29
Camera Settings