Table of Contents
Advertisement
Operation
Instructions
Opening message: the startup screen will
show the software version, communication
protocol, machine address, and
transmission baud rate, etc.
Opening message will disappear after a few
seconds. For its re-display, press the
number "75" key+ PRESET key. (See
"Preset Commands" on page 55.)
Wait the operation until disappearance of
the opening message. Otherwise some
delay of process may occur.
Note
After changing a setting on a menu, wait at
least 20 seconds before turning off the
power of the camera.
If the power is turned off immediately, the
new setting may not be stored correctly.
Activate OSD
Menu
The method to activate the OSD menu may
differ depending on the connected keypad
controller. For a keypad controller that is
compatible with Pelco D keypad controller,
press the number keys "95" and then press
and hold the "Preset" key for 3 seconds to
activate the OSD menu. For other special
functions and key combinations, refer to the
table on page 55.
Horizontal Pan/
Vertical Tilt
Manual horizontal pan
Manual horizontal pan must be controlled
through the joystick on the keypad
controller. The rotation speed is adjustable
between 0.1° - 120°/sec by the position of
the joystick, and the maximum manual
horizontal pan speed is up to 120°/sec.
The limitation of maximum pan speed is
enabled by camera setting.
Manual vertical tilt
Manual vertical tilt speed is adjustable
between 0.1° - 60°/sec, and the speed will
be restricted by the manual speed setup of
pan speed.
Horizontal pan range
Vertical tilt range
Manual vertical tilt
speed
Manual horizontal pan
speed
Preset maximum
rotation speed
Activate OSD Menu / Horizontal Pan/Vertical Tilt
360° continuous
rotation
210°
0.1° - 90°/s
0.1° - 60°/s
Horizontal: 300°/s
Vertical: 300°/s
21
Advertisement
Table of Contents
