Verifying Phone Startup - Cisco SPA 525G User Manual

Figure 1 Cisco SPA 525G/525G2 IP Phone Connections
Number
1
2
3
4
5
6

Verifying Phone Startup

20 C isco S pa 5 25 U ser G uide V
Component
Auxiliary port. Only for use with the Cisco SPA 500S attendant console.
Power port. Insert the power adapter plug into this port.
Additional Ethernet port. Connect an Ethernet cable to this port to provide network
connectivity to a PC. (This port cannot be used when the phone is connected to the
network via the built-in Wireless-G client.)
Switch (Ethernet) port. Connect the network cable to this port.
Phone cord slot. Insert one end of the phone cord into this slot and the other into
the jack at the bottom of the phone handset.
USB port. For use with an external USB memory device (optional). You can also use the
USB port on the Cisco SPA 525G2 model to charge a device such as a Bluetooth-
enabled mobile phone if your phone has a mini-USB port.
After receiving power and network connectivity, the phone executes a boot-up
sequence. During this sequence, the display shows the Cisco logo. All of the lights on the
phone will flash. After the sequence, which should take about five seconds, the phone will
display the standard menu for the phone. The date, name and number of the phone
appear on the top line of the LCD screen. At the bottom of the LCD screen, softkeys
appear over their associated soft buttons.
If the phone does not display this screen, confirm your installation and connections. If
these are correct, try unplugging the phone and plugging it back in again. If you still donʼt
see the display, then contact your Phone Administrator or Internet T elephony Service
Provider (ITSP).
7.11