Fujitsu Sparc Enterprise T5120 Installation Manual page 75

Hide thumbs Also See for Sparc Enterprise T5120:
Table of Contents

Advertisement

You need to modify the ILOM service processor network management port
settings.
In this procedure, you connect to the ILOM service processor using the serial
management port to manually reconfigure the network management port.
Note – For more information on configuring ILOM, refer to the Integrated Lights Out
Manager 2.0 Supplement for SPARC Enterprise T5120 and T5220 Servers.
Set these network parameters according to the specific details of your network
configuration:
/SP/network state – Specifies whether the service processor is on the network
or not
/SP/network pendingipaddress – IP address of the service processor
/SP/network pendingipgateway – IP address of the gateway for the subnet
/SP/network pendingipnetmask – Netmask for the service processor subnet
/SP/network pendingipdiscovery - Specifies whether the service processor
uses DHCP or static IP address assignment
/SP/network commitpending - Commits the service processor to use the
pending settings
Configure these parameters with the set command. The usage is as follows:
set target property=value where /SP/network is the target and
pendingipaddress=xxx.xxx.xxx.xxx, for example, is the property=value.
1. Configure the service processor using information from your network
administrator.
Your choices are:
dhcp - Set up the network connection with a dynamically created IP
configuration. If you choose to use a dynamically created IP address (use
DHCP to retrieve the network setting), set pendingipdiscovery to dhcp.
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
static - Set up the network connection with a static IP configuration. If you
choose to configure a static IP configuration. set the parameters
pendingipdiscovery, pendingipaddress, pendingipgateway, and
pendingipnetmask as follows.
a. Set the service processor to accept a Static IP Address.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
Powering On the System
53

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sparc enterprise t5220

Table of Contents