Assembling And Installing The Dc Input Power Cables; To Assemble The Dc Input Power Cables - Fujitsu Sparc Enterprise T5120 Installation Manual

Assembling and Installing the DC Input
Power Cables
The following procedure describes how to assemble the DC input power cable for the
SPARC Enterprise T5220 server.
Assemble one cable for each DC power supply in your server.
Before you begin the installation procedure, verify that the required conditions
described in the following table have been satisfied.
Prerequisites Not Covered by the DC Cable Installation Procedure
TABLE:
Prerequisite Condition
Install a DC power source that meets the server's input power
specifications.
Secure DC power cables that meet the server's power cabling
specifications.
Attach the DC input plug to the DC input power cables. The input plug
is provided in the server's shipping kit.

▼ To Assemble the DC Input Power Cables

1. Turn off power from the DC power source using the circuit breakers.
Caution – Do not proceed with these instructions until you have turned off the
power from the DC power source through the circuit breakers.
2. Identify the parts that you will use to assemble the DC input power cables.
For each cable, you need the three parts shown in the figure below. These items
are provided in the shipping kit that came with your server (DC models only).
Assembling and Installing DC Power Cables for the SPARC Enterprise T5220 Server
Responsible Party
Customer
Customer
Customer
101