Use this port for server management. This port is needed to set up the service
processor network management port, as detailed in
Network Management Port" on page
Note – Use the service processor serial management port only for server
management. This port is the default connection between the service processor and a
terminal or a computer.
1. Connect a Category 5 cable from the SER MGT serial management port to the
terminal device.
2. When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the
crossovers given for each connector.
Caution – Do not attach a modem to this port.
Related Information
"Enabling the Service Processor Network Management Port" on page 49
■
"To Connect the Service Processor Network Management Port" on page 36
■
▼ To Connect the Service Processor
Network Management Port
The service processor network management port is labeled NET MGT. This port is
located just to the right of the serial management (SER MGT) port on the rear panel.
●
Connect a Category 5 cable from the NET MGT network management port to
your network switch or hub.
36
SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
"Enabling the Service Processor
49.