Restoring Default Outgoing Messages (1 And 2); Automatic Reset; Renewed Operation Start; Showing Received Messages - AEG D 5000 Instruction Manual

Note:
The recorded outgoing message depends on the Operation Mode! The recorded
outgoing message is allocated to the Operation Mode. The length of the outgoing
message must be bigger than 5 seconds and smaller/equal to 2 minutes, or else it
won't be recorded.

Restoring Default Outgoing Messages (1 and 2)

Default Outgoing Messages remain stored, even if you are heading it with your
personal outgoing message.
1. Set the working mode of the device, i.e. "Message and Recording" – (OGM 1) or
"Message Only" (OGM 2).
2. Press rewind key i (27) longer than one second while operating in standby
mode. You hear a signal tone and the LED message lamb is flashing (21).
3. Press the delete key
repeating the default text. The newly recorded outgoing message is deleted.

Automatic Reset

After each local or remote control operation, the device returns to the set mode,
except the memory is full (only in "Message and Recording" mode).

Renewed Operation Start

A Renewed Operation-Start is almost equal to a reset, i.e. the most settings of the
device are returning into the status before the first start.
Attention!
The settings call-mode, number of rings and day/time become deleted.
Messages and memos remain stored.
Pull the power supply plug off the unit, wait about one minute and put the power
supply plug back into the unit.

Showing Received Messages

When receiving a new message, the LED concerning new messages is flashing (21).
Also during a new call it does not stop flashing.
Did you hear the new messages once, the device considers it as old messages, and
the flashing stops. The LED lights to ensure the answering machine is switched on.
(29) until you are hearing a beep and the device is
41