NETGEAR DG834GSP Reference Manual page 143

Figure 8-29: Running a Ping test to the LAN from the PC
This will cause a continuous ping to be sent to the first DG834GSP. After between several
seconds and two minutes, the ping response should change from "timed out" to "reply."
Note: Use Ctrl-C to stop the pinging.
Figure 8-30
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote DG834GSP. After a short wait, you should see the login screen of the
Modem Router (unless another PC already has the DG834GSP management interface open).
• Gateway-to-Gateway Configuration—test the VPN tunnel by pinging the remote network
from a PC attached to the DG834GSP.
a. Open command prompt (i.e., Start -> Run -> cmd).
Virtual Private Networking
Reference Manual for the ADSL Modem Wireless Router DG834GSP
v1.0, June 2007
8-31