Additional Safety Rules - Makita 3601B Instruction Manual

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified o n the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user - as well as damage t o
the tool. If in doubt, DO
NOT PLUG IN THE TOOL. Using a power source
with
voltage less than the nameplate rating is harmful t o the motor.
ADDITIONAL SAFETY RULES
1. Handle the bits very carefully.
2.
Check the bit carefully for cracks or damage before operation. Replace
3.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
4.
Hold the tool firmly w i t h both hands.
5.
Keep hands away from rotating parts.
6.
Make sure the bit is not contacting the workpiece before the switch is turned
on.
7.
Before using the tool o n an actual workpiece, let it run for a while. Watch
for vibration or wobbling that could indicate improperly installed bit.
8.
Be careful of the bit rotating direction and the feed direction.
9. Do
not leave the tool running. Operate the tool only when hand-held.
cracked or damaged bit immediately.
fore operation.
IO.
Always switch o f f and wait for the bit t o come t o a complete stop before
11. Do not touch the bit immediately after operation;
it
may be extremely hot
removing the tool from workpiece.
and could burn your skin.
SAVE THESE INSTRUCTIONS.
4