Additional Safety Rules - Makita 3612C Instruction Manual

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source w i t h voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user - as well as damage t o
the tool. If in doubt, DO
NOT PLUG
IN THE
TOOL. Using a power source w i t h
voltage less than the nameplate rating is harmful t o the motor.
ADDITIONAL SAFETY RULES
1.
Wear hearing protection during extended period of operation.
2.
Handle the bits very carefully.
3.
Check the bit carefully for cracks or damage before operation. Replace
4.
Avoid cutting nails. Inspect for and remove all nails from the workpiece
5.
Hold the tool firmly
with
both hands.
6.
Keep hands away from rotating parts.
7.
Make sure the
bit
is not contacting the workpiece before the switch is turned
8.
Before using the tool on an actual workpiece. let it run for
a
while. Watch
9.
Be careful of the bit rotating direction and the feed direction.
cracked or damaged bit immediately.
before operation.
on.
for vibration or wobbling that could indicate improperly installed bit.
IO. Do
not leave the tool running. Operate the tool only when hand-held.
11. Always switch off and wait for the bit t o come t o a complete stop before
12. Do not touch the bit immediately after operation; it may be extremely hot
removing the tool from workpiece.
and could burn your skin.
SAVE THESE INSTRUCTIONS.
4