Required Fng Context Configuration Information - Cisco ASR 5000 Series Administration Manual

Femto Network Gateway Configuration
Required Description
Information
Security The name or names of the security administrator with full rights to the system.
administrator name
Security Open or encrypted passwords can be used.
administrator
password
Remote access The type of remote access that will be used to access the system, such as ftpd and/or telnetd.
type(s)

Required FNG Context Configuration Information

The following table lists the information that is required to configure the FNG context.
Table 6. Required Information for FNG Context Configuration
Required Information
FNG context name
Configuration for the Secure Interface to the FAPs in the Network
FNG interface name
AAA interface name
Loopback interface
IP addresses and subnet
masks
Physical Ethernet port
number
Gateway IP address
AAA configuration
information
EAP profile name (required
for the EAP authentication
method)
OL-24872-01
Description
An identification string from 1 to 79 characters (alpha and/or numeric) by which the FNG context
is recognized by the system.
An identification string between 1 and 79 characters (alpha and/or numeric) by which the
interface is recognized by the system.
This is the interface that carries the IPSec tunnels between the FAPs in the network and the FNG.
An identification string between 1 and 79 characters (alpha and/or numeric) by which the
interface is recognized by the system.
This is the interface between the AAA server and the FNG.
An identification string between 1 and 79 characters (alpha and/or numeric) by which the
interface is recognized by the system.
This is the FNG loopback interface.
The IPv4 addresses assigned to the FNG, AAA, and loopback interfaces above.
The physical Ethernet port to which the FNG interface will be bound. Ports are identified by the
chassis slot number where the line card resides followed by the number of the physical connector
on the card. For example, port 17/1 identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
The gateway IP address for configuring the IP route from the FNG interface to the FAP network.
Identifies the IP address of the RADIUS AAA server.
When the EAP method is used for FAP authentication, the name of the EAP profile to be used.
Configuring the System to Perform as a Femto Network Gateway ▀
Cisco ASR 5000 Series Femto Network Gateway Administration Guide ▄
37