Makita LS1016 Instruction Manual page 20

1
2
3
009521
2
1
3
009522
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding
stoppers as shown in the figure. Adjust the crown
molding stoppers according to the size of the
crown molding. Tighten the screws to secure the
crown molding stoppers. Refer to the table (C) for
the miter angle.
1
009520
Position in
Miter angle
Fig. A
(1) Right 45°
For inside
corner
(2)
Left 45°
(3)
For outside
corner
(4) Right 45°
006365
1. Crown molding
stopper L
(Optional
accessory)
2. Crown molding
stopper R
(Optional
accessory)
3. Turn base
1. Crown molding
stopper L
2. Crown molding
stopper R
3. Turn base
1. Guide fence
2. Crown molding
2
Table (C)
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
1. Cutting aluminum extrusion
009523
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a
cutting lubricant when cutting the aluminum
extrusion to prevent build-up of the aluminum
material on the blade.
CAUTION:
Never attempt to cut thick or round aluminum
•
extrusions. Thick aluminum extrusions may come
loose during operation and round aluminum
extrusions cannot be secured firmly with this tool.
2. Groove cutting
1
001563
A dado type cut can be made by proceeding as
follows:
Adjust the lower limit position of the blade using
the adjusting screw and the stopper arm to limit the
cutting depth of the blade. Refer to "Stopper arm"
section described previously.
After adjusting the lower limit position of the blade,
cut parallel grooves across the width of the
workpiece using a slide (push) cut as shown in the
figure. Then remove the workpiece material
between the grooves with a chisel. Do not attempt
to perform this type of cut using wide (thick) blades
or with a dado blade. Possible loss of control and
injury may result.
CAUTION:
Be sure to return the stopper arm to the original
•
position when performing other than groove
cutting.
20
1. Guide fence
1
2. Vise
2
3. Spacer block
4. Aluminum
3
extrusion
4
5 5. Spacer block
1. Cut grooves with
blade