Operating Environment - Omega CA450 User Manual

WARNING
■ Always observe the following instructions. Failure to do so may result in
electrical shock or other dangers that may lead to serious injury or the loss
of life.
Test Leads and Lead cables
• Use the products provided by Omega Engineering for this device.
• Do not use degraded or damaged test leads or lead cables.
Check the continuity of the test leads and lead cables.
• When you attach or remove the test leads or lead cables or remove the case (for example
to change the batteries), be sure to remove the lead cables from the circuit under
measurement.
• When you remove the case (for example to change the batteries), be sure to remove the
test leads and lead cables from the instrument.
• There are caps at the ends of the test leads. To ensure safety (safety standard
EN600-0), be sure to put the caps on the leads when you use them.
Casing
• Do not use the instrument if there is any damage to the casing or when the casing is
removed.
Fuses
• Use fuses of the specified rating when the fuse is replaced.

Operating Environment

• Do not operate the instrument in an atmosphere where any flammable or explosive gas is
present.
• Avoid using the instrument if it has been exposed to rain or moisture or if your hands are
wet.
Disassembly
• No person, the specified engineer, is authorized to disassemble this instrument.