Sensor Mode Input, Display, And Unit Settings - Omega CA450 User Manual

1) Press the LIGHT or SHIFT key to display "bEEP."
(Turn the buzzer on and off in the subdisplay. The initial setting is on.)
2) Use the ▲ (RANGE) and ▼ (REL) keys to select ON or OFF.
3) Press the HOLD key to save the setting.
(After "SEt" appears, "bEEP" will appear again.)
) To return to normal measurement from setup mode, hold down the LIGHT key for 
second or longer.
4.6.2

SENSOR Mode Input, Display, and Unit Settings

For SENSOR mode (mV position on the function switch), you can set the input voltage and the
corresponding main display and unit for that input voltage.
1) Press the LIGHT or SHIFT key to display the screen shown below. The parameter that
can be changed blinks.
Subdisplay 4
Main display 4
Main decimal place
Keep pressing the LIGHT key to switch between the following parameters.
Subdisplay , subdisplay , subdisplay 2, subdisplay , main display , main display ,
main display 2, main display , main decimal place, and main unit
(You can press the SHIFT key to switch parameters in the opposite direction.)
2) Use the ▲ (RANGE) and ▼ (REL) keys to set the various values, the decimal place,
and the unit.
3) Press the HOLD key to save the settings. (After "SEt" appears, the setting screen will
appear again.)
) To return to normal measurement from setup mode, hold down the LIGHT key for 
second or longer.
:ON
:OFF
HOLD
Subdisplay 1
Main unit
Main display 1