Mounting Of Control Cable - Makita EBH340U Instruction Manual

MOUNTING OF CONTROL CABLE

– Remove the air cleaner cover.
– Place the control cable (1) in the adjusting bolt (2), and
shift the swivel (3) so that the cable will be put in the
swivel groove. At this time, the round-hole side of the
swivel will be oriented toward the inner wire end-metal
fitting.
– Release the swivel, and confirm that the inner wire-end
metal fitting will be placed in the hole.
– Mount the air cleaner cover.
CONNECTION OF SWITCH CORD
– Connect the switch cords to the two cords from the engine
by inserting one into the other.
– Fix the cord connector by clamp (4).
ADJUSTMENT OF CONTROL CABLE
Adjust the control cable by adjusting bolt so that it will have
1 to 2 mm play when the throttle lever is set to the
low-speed position by carburetor adjusting bolt. (Be careful
that the cutter blade will not turn in idling.)
(1)
Control cable
Round-hole
13
(2)
Insert
End fitting
1-2 mm
(3)
Swivel
(4)