Mounting The Cutter Guard - Makita BCM2600 Instruction Manual

Installing the cutter guard
Important: Safety regulations and your own safety make
it imperative to use the right cutter guard with a given
cutting tool!
Tool/guard combinations for the BCM2600 / BCM3300 / BCM4300
Cutting tool
4-tooth star blade: Part no. 362 224 140
Outside diameter: 230 mm (9"), arbour: 25.4 mm (1")
2-line trimmer head Part no. 351 502 030
15 m Part no. 369 224 670
120 m Part no. 369 224 672
Tool/guard combinations for the BCM2310 / BCM2610 / BCM3310
Cutting tool
2-line trimmer head Part no. 351 502 030
15 m Part no. 369 224 670
120 m Part no. 369 224 672
A
6
7
B
8
10
Warning: Use only the cutting tools shown here! It is not
permitted to use other cutting tools as this can increase dan-
ger of accidents and cause damage to the equipment!
Cutter guard
Part no. 351 504 101
Part no. 351 504 101
and
Part no. 351 504 102
Install the guard extension
Cutter guard
Part no. 351 504 101
and
Part no. 351 504 102
Install the guard extension

Mounting the cutter guard

- Hook the hood (A/5) by the cutout (A/1) on the lug (A/2).
- Insert and tighten bolt (A/3) and nut (A/4).
Mounting the guard extension for use with trimmer head.
- See above for installation of the cutter guard.
- Attach the guard extension (B/6) supplied with the brushcut-
ter to the upper part of the cutter guard (A/5), bending it to
fi t the contour of the guard.
- Attach the trimmer line knife (B/7) to the guard extension
(B/8) with the bolt (B/6).
Note: If the trimmer line has been extended (see "Adjusting
the line") the trimmer line knife automatically cuts the line
ends to the same length during use.