Err Led; Reset Button - Cisco Small Business NSS3000 Series Administration Manual

Troubleshooting

Reset Button

Reset Button
Cisco Small Business NSS3000 Series Network Storage System Administration Guide

ERR LED

The ERR LED states indicates that the disk drive is in an error condition. These are
the LED colors and their meanings
•
Solid Red: The disk drive is in a failed state.
•
Blinking Red: The disk drive is predicated to fail (via S.M.A.R.T.). We
recommend that you replace the disk drive to avoid the loss of data.
•
Off: The drive is OK.
Off: There is either no UPS attached to the NSS or the UPS function has been
disabled in the System Power page in the configuration interface.
On: A UPS is attached to the NSS and the UPS function is enabled in the System
Power page in the configuration interface.
Use the Reset button to restore the network setting system defaults or to reset the
box. The Reset button is located to the left of the display button on the front panel
of the NSS. You might need to use a pen or the end of a straightened paperclip to
press the button.
•
To restore the network setting system defaults
Shut down the NSS, press the Reset button, and then power up the NSS.
When you see the Power LED blink yellow rapidly, release the Reset button.
The network settings are restored to the factory defaults.
•
To reset the NSS
Press and hold the Reset button while the system is running until the Power
LED blinks green. Release the Reset button.
A
96